User Guide

Project Status Report

To get an email report of when a project has completed you can add an Project Status Report step to the project.

Configuration

If you wish to receive the report for all status' set the run condition to Any.

If you only wish to receive the report when the project has been successful set the run condition to Success, which will ensure the step runs when the previous steps have been successful. Or, set the run condition to SuccessWithDataChanges, to receive the report when the project has run successfully with data changes.

If you only wish to receive the report when the project has failed then set the run condition to Failure.

Emails are sent from the Simego Online Service

Parameter Value
To & Cc Email addresses to send the report to separated with a ;
Subject Enter in an email subject by default this will use the project name followed by - Status Report

Status Email Configuration

Result

Below are examples of the email reports that will be sent:

Success

Success Email

Failure

Failure Email